ZACplus Citizen-Science Workshop vom 03.07.2026: Unterschied zwischen den Versionen

Neueste Überarbeitung vom 13. Oktober 2026, 17:28 Uhr

Online-Workshop vom 03.07.2026, Printing the 3d-printable parts

Print the 3D-printable parts with PLA . This are the endplates (one with and one without hole) and we make a stencil for punching-holes for the metal-plates, in case we produce them manually instead of milling them.

Endplates

Endplate with Hole

Endplate with pin

Stencils

Stencil for Grafoil

Stencil for Brass- and Copper-plate

Here are very small holes in it which help marking the exact middle of a bigger hole, but are small enough to to can be used with a scriber without any margin (and therefore delivers the exact point).

Stencil for Silicone-Gasket

Here i have simply used the Model for the static frame. When using it as a stencil its maybe a good idea to print it with a thickness of only 1 mm or less.

@@ Zeile 7: / Zeile 7: @@
 ==== Endplate with Hole ====
+<gallery widths="800" heights="600" perrow="2>
+File:Endplate_with_hole.jpg
+</gallery>
 ==== Endplate with pin ====
+<gallery widths="800" heights="600" perrow="2>
+File:Endplate_with_pin.jpg
+</gallery>
@@ Zeile 18: / Zeile 27: @@
 ==== Stencil for Grafoil ====
+<gallery widths="800" heights="600" perrow="2>
+File:Grafoil.jpg
+</gallery>
 ==== Stencil for Brass- and Copper-plate ====
+Here are very small holes in it which help marking the exact middle of a bigger hole, but are small enough to to can be used with a scriber without any margin (and therefore delivers the exact point).
+<gallery widths="800" heights="600" perrow="2>
+File:Brasscopper.jpg
+</gallery>
 ==== Stencil for Silicone-Gasket ====
+Here i have simply used the Model for the static frame. When using it as a stencil its maybe a good idea to print it with a thickness of only 1 mm or less.
+<gallery widths="800" heights="600" perrow="2>
+File:Silicone.jpg
+</gallery>