ZACplus Citizen-Science Workshop vom 03.07.2026: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
Case (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „== Online-Workshop vom 03.07.2026, Printing the 3d-printable parts == Print the 3D-printable parts with PLA . This are the endplates (one with and one without…“) |
Case (Diskussion | Beiträge) |
||
| Zeile 2: | Zeile 2: | ||
Print the 3D-printable parts with PLA . This are the endplates (one with and one without hole) and we make a stencil for punching-holes for the metal-plates, in case we produce them manually instead of milling them. | Print the 3D-printable parts with PLA . This are the endplates (one with and one without hole) and we make a stencil for punching-holes for the metal-plates, in case we produce them manually instead of milling them. | ||
| + | |||
| + | === Endplates === | ||
| + | |||
| + | |||
| + | ==== Endplate with Hole ==== | ||
| + | |||
| + | |||
| + | ==== Endplate with pin ==== | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | === Stencils === | ||
| + | |||
| + | |||
| + | ==== Stencil for Grafoil ==== | ||
| + | |||
| + | |||
| + | ==== Stencil for Brass- and Copper-plate ==== | ||
| + | |||
| + | |||
| + | ==== Stencil for Silicone-Gasket ==== | ||
Version vom 13. Oktober 2026, 17:18 Uhr
Online-Workshop vom 03.07.2026, Printing the 3d-printable parts
Print the 3D-printable parts with PLA . This are the endplates (one with and one without hole) and we make a stencil for punching-holes for the metal-plates, in case we produce them manually instead of milling them.